1911 Forums : 1911Talk banner
1 - 5 of 5 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Well my fusion kit came in. All I pretty much have to do is fit all the small parts and trigger.

I was really excited to open it up and start assembly, but then once I relized all the grinding and fitting I would have to do I got a little scared.

I have the slide together and fitted up with all of its internals already but now I have to do the frame stuff. I started with the thumb safety and it was really difficult to tell where I needed to grind it up to fit.

Then I tried to put the trigger stuff in, Im not even sure how much fitting the trigger, sear and disconector need. I ordered a semi fitted kit.

Anyway, ill pull it all back out and fiddle with it some more.
 

·
Forum Supporter
Joined
·
141 Posts
Keep your chin up. Call Bob if you have any questions.

It is not just the destination...


It is the journey.
 

·
Registered
Joined
·
36 Posts
Keep your chin up. Call Bob if you have any questions.

It is not just the destination...


It is the journey.
Amen :wink:

The fitting that is needed is minimal and easy if you take it slow. I called and talked to Bob who helped overcome the one issue I had.

Keep us posted.
 
1 - 5 of 5 Posts
Top