1911 Forums : 1911Talk banner
1 - 10 of 10 Posts

·
Registered
Joined
·
4,029 Posts
well its not a 4" barrel as les dont make them 4 1/4 yes since it had a bushing for 1k buy it,,

One way to verify the specs is get the serial # and call les baer they will tell you how it left the factory
 

·
Premium Member
Joined
·
1,556 Posts
Its worth $1000 even if it needs minor work.

+1 on calling Les and verifying how it was setup when it left his shop.
 

·
Registered
Joined
·
473 Posts
Discussion Starter · #4 ·
well its not a 4" barrel as les dont make them 4 1/4 yes since it had a bushing for 1k buy it,,

One way to verify the specs is get the serial # and call les baer they will tell you how it left the factory
Good info. He doesn't seem to know a lot about Les Baers and I didn't know enough about them either to ask.

They only concern I have is how tight it is and whether it will run without oil.......just kidding!! ;)
 

·
Premium Member
Joined
·
1,556 Posts
Those don't look like Baer sights ...he uses a Novak knockoff (of his own design)...

EDITED to add: They may be an older version of his sights...Ping could verify that.
 

·
Registered
Joined
·
473 Posts
Discussion Starter · #6 ·

·
Unemployed
Joined
·
218 Posts
Those don't look like Baer sights ...he uses a Novak knockoff (of his own design)...

EDITED to add: They may be an older version of his sights...Ping could verify that.
Les used to use MMC sights, so if it's' an older gun, they probably are original. And they're good sights.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top