1911 Forums : 1911Talk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My friend told me about a magazine catch that is machined .025"-.030 higher at the lock up step to bring the magazine closer to the bottom of the frame. Anyone know where I can get one? I have looked in Brownells and they don't have one. Thank you for you help
 

·
Registered
Joined
·
4,029 Posts
EGW makes it as Jerry said it works well for guns with the mag release hole slightly out of spec ..
 

·
Registered
Joined
·
174 Posts
It's a Grieder? design, George at EGW put one in a problematic Kimber I had, works good, funny thing is that he was saying that it was not an intentional design, but an "oops" that just worked well.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top