1911 Forums : 1911Talk banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
5,072 Posts

·
Premium Member
Joined
·
5,072 Posts
That's the only caveat, getting the correct angle to get to it properly. That and getting the tip sized. You are pobably better off getting that one, but it's not a big jump to machining the slide for a dovetail sight. If you plan on doing more though the tool would be a good investment.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top